DeLonghi ETAM29.62X, Инструкция по эксплуатации

Страница: 20 / 23

19
2. Press (B4) or (B5) (fig. 7) and select “Water
hardness”.
3. Confirm the selection by pressing the OK icon (B1) (fig. 4).
4. Press or repeatedly to set the level as meas-
ured by the indicator paper (see previous section).
5. Press the
OK
icon to confirm the setting.
6. Press the icon to exit the menu.
The machine is now reprogrammed with the new water hard-
ness setting.
15. WATER SOFTENER FILTER (*CERTAIN MODELS
ONLY)
Certain models are fitted with a water softener filter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De’Longhi Customer Services.
To use the filter correctly, follow the instructions below.
15.1 Installing the filter
34
1. Remove the filter (C4) from
the packaging.
2. Turn the date indicator disk
(see fig. 34) until the next 2
months of use are displayed.
Please note
The filter lasts about two
months if the appliance is used
normally. If the coffee machine
is left unused with the filter in-
stalled, it will last a maximum of
three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in the figure until water comes out of the
openings at the side for more than a minute (fig. 35).
35 36
0,5 L
4. Extract the tank (A20) from the appliance and fill with
water.
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 37).
6. Insert the filter in the filter housing (A21) (fig. 36) and
press as far as it will go.
7. Close the tank with the lid (A22) (fig. 38), then replace the
tank in the machine.
37 38
When you install the filter, you must notify the appliance of its
presence.
8. Press the
icon (B2) to enter the menu;
9. Press (B4) or (B5) until “Install filter” appears
on the display (B3).
10. Press the OK icon (B1) (fig. 4).
11. “Enable?” is displayed.
12. Press the
OK
icon to confirm the selection. “HOT WATER
Press OK” is displayed.
13. Place a container underneath the cappuccino maker (A8)
(min. capacity: 500ml) (fig. 5).
14. Press the
OK
icon to confirm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
15. After the flow of hot water stops, the appliance automati-
cally resets to “Ready for coffee” status.
The filter is now active and you can use the coffee machine.
15.2 Replacing the filter
When “REPLACE FILTER” appears on the display (B3), after two
months (see date indicator) or when the appliance has not been
used for 3 weeks, you should replace the filter:
1. Extract the tank (A20) and exhausted filter (C4).
2. Take the new filter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section.
3. Place a container underneath the cappuccino maker (min.
capacity: 500ml).
4. Press the icon (B2) to enter the menu;
5. Press (B4) or (B5) (fig. 7) until “Replace filter”
is displayed.
6. Press the OK icon (fig. 4).
7. The message “Confirm?” is displayed.
8. Press the
OK
icon to confirm the selection.
9. “HOT WATER Press OK” is displayed.
10. Press the
OK icon to confirm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
11. After the flow of hot water stops, the appliance automatically
resets to “Ready for coffee” status.
The new filter is now active and you can use the coffee machine.
15.3 Removing the filter
If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Remove the tank (A20), remove the filter (C4) and put the
tank back in the appliance.
2. Press the icon (B2) to enter the menu.
3. Press (B4) or (B5) (fig. 7) until “Install filter,
Enabled” appears on the display (B3).
4. Press the OK icon (B1) (fig. 4).
5. “Disable?” appears on the display.
6. Press the
OK icon to confirm and the icon to exit the
menu.
16. TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 1,5MPa (15 bar)
Max. water tank capacity: 1,4 l
Size LxDxH: 195x480x340 mm
Cord length: 1100 mm
Weight: 9,3 kg
Max. beans container capacity: 200 g
The appliance complies with the following EC
directives:
• European Standby Regulation 1275/2008
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
17. DISPOSING OF THE APPLIANCE
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.