DeLonghi ETAM29.62X, Инструкция по эксплуатации

Страница: 12 / 23

11
4. Press the
OK
icon: after a few seconds, hot water is delivered
from the coffee spouts to clean and heat the appliance’s in-
ternal circuit.
Please note!
• To stop delivery at any time, press any icon.
• If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use.
8.2 Descaling
For instructions on descaling, see section “13. Descaling”.
8.3 Install filter
For instructions on how to install the filter, see section “15.
Water softener filter (*certain models only)”.
8.4 Replacing the filter (if installed)
For instructions on how to replace the filter, see section “15.2
Replacing the filter”.
8.5 Adjust time
To adjust the time on the display (B3), proceed as follows:
1. Press the icon (B2) to enter the menu.
2. Press (B4) or (B5) (fig. 7) until “Adjust time” is
displayed.
3. Press the OK icon (B1) (fig. 4). The hours flash on the
display.
4. Press or to change the hour.
5. Press the
OK
icon to confirm. The minutes flash.
6. Press or to change the minutes.
7. Press the
OK
icon to confirm.
This sets the time. Press the icon to exit the menu.
8.6 Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coffee immediately.
Please note!
To enable this function, the time must already be set correctly.
To enable auto-start, proceed as follows:
1. Press the
icon (B2) to enter the menu.
2. Press (B4) or (B5) (fig. 7) until “Auto-start”
appears on the display (B3).
3. Press the
OK
icon (B1) (fig. 4). “Enable?” is displayed.
4. Press the
OK
icon to confirm.
5. Press or to choose the hour.
6. Press the OK icon to confirm.
7. Press or to change the minutes.
8. Press the OK icon to confirm.
9. Then press the icon to exit the menu.
Once the time has been confirmed, activation of auto-start is
indicated by the
symbol displayed alongside the time.
To disable the function:
1. Select auto-start from the menu.
2. Press the
OK icon. “Disable?” is displayed.
3. Press the OK icon to confirm.
The symbol is no longer displayed .
8.7 Auto-off (standby)
Auto-off can be set so that the appliance goes off after 15 or 30
minutes, or 1, 2 or 3 hours.
To programme Auto-off, proceed as follows:
1. Press the
icon (B2) to enter the menu.
2. Press (B4) or (B5) (fig. 7) until “Auto-off” ap-
pears on the display (B3).
3. Press the
OK
icon (B1) (fig. 4).
4. Press or until the required operating time (15
or 30 minutes, or 1, 2 or 3 hours) is displayed.
5. Press the OK icon to confirm.
6. Then press the icon to exit the menu.
Auto-off is now programmed.
8.8 Energy saving
Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
To disable (or enable) energy saving, proceed as follows:
1. Press
the icon (B2) to enter the menu.
2. Press (B4) or (B5) (fig. 7) until “Energy Saving”
appears on the display (B3).
3. Press the OK icon (B1) (fig. 4). “Disable?” is displayed (or
“Enable?” if the function has been disabled).
4. Press the
OK
icon to disable (or enable) energy saving
mode.
5. Then press the icon to exit the menu.
When the function is active, if the machine is not used for some
time, “Energy saving” is displayed.
Please note!
• When in energy saving mode, a few seconds may elapse
before the first coffee is delivered as the appliance must
heat up again.
• To prepare any beverage, press any icon to exit energy sav-
ing, then press the icon corresponding to the beverage you
want to make.
• To turn the appliance on, press the button (A5) (fig.
6). The message “Heating up Please wait” appears on the
display (B3).
When heating is complete, the message changes to “Rinsing”. As
well as heating the boiler, this also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coffee appears.
7. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A10). Avoid contact with splashes of water.
• To turn the appliance off, press the
button (A10) (fig.
6).
• The message “Turning off Please wait” appears on the dis-
play (B3), then the appliance performs a rinse cycle and
goes off (standby).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• first turn the appliance off by pressing the
button
(fig. 6);
• Press the main switch (A16) on the side of the appliance
(fig. 1).
Important!
Never press the main switch while the appliance is on.
8. MENU SETTINGS
8.1 Rinsing
Use this function to deliver hot water from the coffee spouts
(A10) to clean and heat the appliance’s internal circuit.
Place a container with a minimum capacity of 100ml under the
coffee spout.
To enable the function, proceed as follows:
1. Press the icon (B2) to enter the menu.
2. Press (B4) or (B5) (fig. 7) until “Rinsing” ap-
pears on the display (B3).
3. Press the
OK
icon (B1) (fig. 4) to confirm, “Confirm?” is
displayed.
Important! Danger of burns.
Do not leave the appliance unattended while hot water is being
delivered.