Dell PowerEdge R630, Руководство пользователя

Страница: 146 / 207

Installing an AC power supply unit
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
1. Follow the safety guidelines listed in the Safety instructions section.
2. For systems that support redundant power supply units (PSUs), ensure that both the PSUs are of the
same type and have the same maximum output power
3. If installed, remove the PSU blank.
Steps
1.
Slide the new PSU into the chassis until the PSU is fully seated and the release latch snaps into place.
NOTE: If you unlatched the cable management arm, relatch it. For information about the cable
management arm, see the rack documentation of your system.
2. Connect the power cable to the PSU and plug the cable into a power outlet.
CAUTION: When connecting the power cable, secure the cable with the strap.
NOTE: When installing, hot swapping, or hot-adding a new PSU, wait for 15 seconds for the
system to recognize the PSU and determine its status. The power supply redundancy may not
occur until discovery is complete. Wait until the new PSU is discovered and enabled before you
remove the other PSU. The PSU status indicator turns green to signify that the PSU is
functioning properly.
Figure 71. Installing an AC PSU
1. release latch 2. PSU cable connector
3. PSU 4. power connector
146