120
Item Connector
Description
15
USB2
USB port
16
USB1
USB port
17
TPM
TPM connector
18
J_BP
Hard drive backplane connector
Disabling a forgotten password
The software security features of blade include a system password and a setup password. The password jumper enables these
password features or disables them, and clears any password(s) currently in use.
Prerequisite
CAUTION: Many repairs may only be done by a
certified
service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
Steps
1.
Turnoff the blade by using the operating system commands or the CMC.
2.
Remove the blade from the enclosure to access the jumpers.
3.
Move the jumper on the system-board jumper from pins 2 and 3 to pins 1 and 2.
4.
Install the blade in the enclosure.
5.
Turnon the blade.
When the blade is turned on, power indicator turns on to solid green. Allow the blade to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password jumper on pins 2 and 3. However,
beforeyouassign anewsystem and/orsetup password, you must reinstall the password jumper back to pins 1 and 2.
NOTE: If you assign a new system and/or setup password with the jumper on pins 1 and 2, the system disables the
new password(s) the next time it boots.
6.
Turnoff the blade by using the operating system commands or the CMC.
7.
Remove the blade from the enclosure to access the jumpers.
8.
Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3.
9.
Install the blade in the enclosure.
10.
Turnon the blade.
11.
Assignanewsystemand/orsetuppassword.
