Dell PowerEdge DR715, Руководство владельца оборудования

Страница: 66 / 230

66
Installing System Components
Front Drive Bezel
The front drive bezel is the cover for the optional optical drive, floppy drive,
tape drive, or hot-plug hard drives (when available). To remove or install any
of these drives, you must first remove the front drive bezel.
NOTE:
If you are removing or installing a hot-plug hard drive (when available), the
system may remain turned on and in the upright position when removing the front
drive bezel (see "Removing a Hot-plug Hard Drive" on page 88). If you plan to remove
or install any other system components, the system should be in the orientation
shown in Figure 3-1 (see "Opening the System" on page 68).
Removing the Front Drive Bezel
1
Using the system key, unlock the bezel.
2
Slide the lever in the direction of the arrow until it releases the bezel from
the top of the chassis (see Figure 3-2).
3
Rotate the top end of the bezel away from the chassis, and lift the bezel
out from the chassis, removing the bezel tabs from the slots as shown in
Figure 3-2.
Installing the Front Drive Bezel
1
Insert the bezel tabs into the bezel tab slots in the chassis (see Figure 3-2).
2
Firmly press the top end of the bezel into the chassis until the lever locks
into place.
3
Using the system key, lock the bezel.
9 control panel 10 optical disk drive
11 5.25" drive bay 12 3.5" floppy drive
13 front drive bezel 14 expansion card fan
15 3.5" hard drives 16 system board
17 system memory