Dell PowerConnect J-SRX210, Руководство по оборудованию

Страница: 105 / 182

Connecting to the CLI at the User End for the J-SRX210 Services Gateway
To remotely connect to the CLI through a dial-up modem connected to the console port
on the services gateway:
1.
Connect a modem at your remote location to a management device such as a PC
or laptop computer.
2.
Start your asynchronous terminal emulation application (such as Microsoft Windows
HyperTerminal) on the PC or laptop computer.
3.
Select the
COM
port to which the modem is connected (for example,
COM1
).
4.
Configure the port settings shown in Table 35 on page 89.
Table 35: Port Settings for Connecting CLI at User End
Value Port Settings
9600 Bits per second
8 Data bits
None Parity
1 Stop bits
None Flow control
5.
In the HyperTerminal window, enter
AT
.
For more information on the AT commands, see the JUNOS Software Administration
Guide .
An
OK
response verifies that the modem can communicate successfully with the
COM
port on the PC or laptop.
6.
Dial the modem that is connected to the console port on the services gateway by
entering
ATDT remote-modem-number . For example, if the number of the modem
connected to the console port on the services gateway is 0013033033030 , enter
ATDT 0013033033030 .
The services gateway login prompt appears.
7.
Log in as the user
root
. No password is required at initial connection, but you must
assign a root password before committing any configuration settings.
Related Topics
•
Connecting the Modem at the J-SRX210 Services Gateway End on page 87
•
Connecting the Modem to the Console Port on the J-SRX210 Services Gateway on
page 88
•
J-SRX210 Services Gateway Software Configuration Overview on page 91
89
Chapter 15: Connecting the J-SRX210 Services Gateway to Management Devices