12.
Exit system setup, and reboot the computer.
13.
Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
14.
Test the hard drive by running the Dell Diagnostics (see
Dell Diagnostics
).
15.
If the drive you just installed is the primary drive, install your operating system on the hard drive.
Adding a Second Hard Drive
1.
Check the documentation for the drive to verify that it is configured for your computer.
2.
Follow the procedures in
Before You Begin
.
3.
Remove the plastic hard-drive bracket from the inside of the hard-drive bay by squeezing the release tabs and gently pulling the bracket up and out of
the bay.
4.
Gently spread the sides of the drive bracket and slide the hard drive into the bracket until the drive clicks into place.
5.
Move the first hard drive from the upper bay to the lower bay:
a.
Disconnect the power and the data cables from the back of the first hard drive.
b.
Press in on the blue release tabs on each side of the drive and slide the first hard drive up and out of the upper bay.
c.
Gently slide the first hard drive into the lower bay until it clicks into place.
6.
Carefully slide the new hard drive into the upper bay until it clicks into place.
7.
Connect the power cable to the drives.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
NOTICE:
If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.