Installing the power switch
1.
Slide the power switch module into the slot on the chassis until it clicks into place.
2.
Connect the power switch cable to the connector on the system board.
3.
Install the:
a.
power supply unit
b.
optical drive
c.
hard drive assembly
d.
front bezel
e.
cover
4.
Follow the procedure in
After Working Inside Your Computer
.
Removing the SD card reader
1.
Follow the procedure in
Before Working Inside Your Computer
.
2.
Remove the:
a.
cover
b.
front bezel
c.
hard drive assembly
d.
optical drive
e.
power supply unit
3.
To remove the SD card reader:
a. Remove the power supply unit cables from the retention clips on the SD card reader enclosure
[1].
b. Remove the screws that secure the SD card reader and lift it away from the computer [2] [3].
23
Содержание OptiPlex 7040
Страница 1: ...OptiPlex 7040 Small Form Factor Owner s Manual Regulatory Model D11S Regulatory Type D11S001 ...
Страница 7: ...5 If required verify that the computer works correctly by running Dell Diagnostics 7 ...
Страница 30: ...29 Internal USB connector 30 SATA1 connector 31 Coin cell battery 30 ...
