Installing the memory module
1.
Align the notch on the memory module with the tab on the memory module connector.
2.
Insert the memory module into the memory module socket.
3.
Press the memory module until the memory module retention tabs click into place.
4.
Install the:
a.
optical drive
b.
hard drive assembly
c.
fan duct
d.
cover
5.
Follow the procedure in
After Working Inside Your Computer
.
Removing the intrusion switch
1.
Follow the procedure in
Before Working Inside Your Computer
.
2.
Remove the:
a.
cover
b.
fan duct
3.
To remove the intrusion switch:
a. Disconnect the intrusion switch cable from the connector on the system board [1][2].
b. Slide the intrusion switch and lift it away from the computer [3].
Installing the intrusion switch
1.
Insert the intrusion switch into the slot on the chassis.
2.
Connect the intrusion switch cable to the system board.
3.
Install the:
a.
fan duct
b.
cover
4.
Follow the procedure in
After Working Inside Your Computer
.
11
Содержание OptiPlex 7040
Страница 1: ...OptiPlex 7040 Small Form Factor Owner s Manual Regulatory Model D11S Regulatory Type D11S001 ...
Страница 7: ...5 If required verify that the computer works correctly by running Dell Diagnostics 7 ...
Страница 30: ...29 Internal USB connector 30 SATA1 connector 31 Coin cell battery 30 ...
