Dell N2000 Series, Руководство по настройке

Страница: 474 / 1460

474
Configuring iSCSI Optimization
The following commands show how to configure the iSCSI example depicted
in Figure 17-6. Remember that iSCSI optimization is enabled by default.
1 Set the system MTU to 9216 to enable the use of jumbo frames.
console# config
console(config)# system jumbo mtu 9216
2 Optionally configure the switch to associate CoS queue 5 with detected
iSCSI session traffic.
console(config)# iscsi cos enable
console(config)# exit
The default target port and IP address criteria is used to determine which
packets are snooped for iSCSI session data (ports 860 and 3260; any IP
address).
3 If the array is a Compellent storage array, execute the Compellent macro
on the ports attached to the array:
console# config
console(config)# macro global apply profile-compellent-nas
$interface_name te1/0/21
console(config)# macro global apply profile-compellent-nas
$interface_name te1/0/22
console(config)# macro global apply profile-compellent-nas
$interface_name te1/0/23
To configure a N4000 switch in a lossless DCBX environment where another
switch connected to storage arrays supplies the DCBX configuration, perform
the following steps starting with a default configuration:
1 Enter global configuration mode and configure the system MTU on the
switch.
console# configure
console(config)# system jumbo mtu 9216
2 Create VLAN 100. This command also enters the VLAN configuration
mode for VLAN 100.
console(config)# vlan 100
console(config-vlan100)# exit
3 Enable VLAN tagging to allow the CNA ports 1-4 to carry 802.1p priority
values through the network.
console(config)# interface range te1/0/1-4