Dell N2000 Series, Руководство по настройке

Страница: 756 / 1460

756
Configuring the Spanning Tree Protocol
RSTP-PV Access Switch Configuration Example
In this configuration, all 1G ports are presumed to be connected to host
machines, and the two 10G uplink ports are connected to an aggregation-
layer switch with a total L2 network diameter of 4. The aggregation-layer
switch can be a single switch or multiple switches, running either RSTP-PV or
MSTP. For fastest convergence during failover scenarios, it is recommended
that the uplink switches be configured in RSTP-PV mode.
Three VLANs are configured in addition to VLAN 1. Te1/0/1 is configured to
be the primary uplink port and Te1/0/2 is configured to be the backup uplink.
1
Configure VLANs 2 through 4 and return to Global Config mode.
console# configure
console(config)# vlan 2-4
console(config-vlan2-4)# exit
2 Enable RSTP-PV.
console(config)# spanning-tree mode rapid-pvst
3 Configure for a maximum network diameter of 4.
console(config)# spanning-tree vlan 1-4 max-age 16
4 Configure access and trunk ports
console(config)# interface range gi1/0/1-48
console(config-if)# switchport mode access
console(config-if) exit
console(config)# interface range te1/0/1-2
console(config-if)# switchport mode trunk
console(config-if)# exit
5
Configure interface te1/0/1 as the preferred uplink.
console(config)# interface te1/0/1
console(config-if)# spanning-tree port-priority 112
console(config-if)# exit
6
Assign ports to VLANs.
console(config)# interface range gi1/0/1-12
console(config-if)# switchport access vlan 1
console(config-if)# exit
console(config)# interface range gi1/0/1-12
console(config-if)# switchport access vlan 2