44
About Your System
Invalid PCIe card
found in the
Internal_Storage
slot!
The system halted because
an invalid PCIe expansion
card is installed in the
dedicated storage controller
slot.
Remove the PCIe expansion
card and install the
integrated storage controller
in the dedicated slot.
See "Integrated Storage
Controller Card" on
page 112.
Keyboard
controller
failure.
Faulty keyboard controller;
faulty system board
See "Getting Help" on
page 189.
Keyboard data
line failure.
Keyboard stuck
key failure.
Keyboard cable connector is
improperly connected or the
keyboard is defective.
Reseat the keyboard cable. If
the problem persists, see
"Troubleshooting a USB
Device" on page 156.
Keyboard fuse has
failed.
Overcurrent detected at the
keyboard connector.
See "Getting Help" on
page 189.
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings.
The USB ports are disabled
in the system BIOS.
Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s).
See "Entering the System
Setup Program" on page 58.
Manufacturing
mode detected.
System is in manufacturing
mode.
Reboot to take the system
out of manufacturing mode.
Maximum rank
count exceeded.
The following
DIMM has been
disabled:
x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 131.
Table 1-2. System Messages
(continued)
Message
Causes
Corrective Actions
Содержание DX6000
