Dell DX6000, Руководство владельца оборудования, Страница: 142 / 198

142
Installing System Components
6 Align the notches in the processor with the socket keys on the ZIF
socket. See Figure 3-27.
7 Install the processor in the socket. Keep the processor level
(See Figure 3-27) and insert it straight down into the socket. Allow the
processor to float on the pins, allowing the processor shield to hold it
in place.
8 Verify that the processor is properly aligned and seated.
9
Close the processor shield. See Figure 3-27.
10
Rotate the socket-release lever down until it snaps into place. See Figure 3-27.
11
Install the heat sink.
NOTE:
Your kit may contain a replacement heat sink if you are installing a
processor that consumes additional power. The new heat sink may not appear
different than the original one; however, it has improved thermal dissipation
specifications and must be used.
a
Using a clean lint-free cloth, remove the thermal grease from the heat
sink.
CAUTION:
Applying too much thermal grease can result in excess grease coming
in contact with and contaminating the processor socket.
b
Open the grease applicator included with your processor kit and apply
all of the thermal grease in the applicator to the center of the topside
of the new processor.
c
Place the heat sink on the processor. See Figure 3-26.
d
Close the heat-sink release levers or replace the screws at the corners
of the heat sink. See Figure 3-26.
12
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 104.
13 Close the system. See "Closing the System" on page 83.
14 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
15 Press <F2> to enter the System Setup program, and check that the
processor information matches the new system configuration.
See "Entering the System Setup Program" on page 58.