Dell D03T, Руководство по обслуживанию

Страница: 79 / 119

Steps
1. Insert the intrusion switch into its slot in the chassis.
2. Route the intruder cable through the routing guides on the system board.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the air shroud .
2. Install the side cover .
3. Follow the procedure in After working inside your computer .
Internal hard-drive cage
Removing the internal hard-drive cage
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
3. Remove the air shroud .
4. Remove the 2.5-inch hard-drive assembly .
5. Remove the 3.5-inch hard-drive assembly .
About this task
The following images indicate the location of the internal hard-drive cage and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the SATA power-cables and SATA data-cables from the connectors on the system board.
2. Remove the five (#6-32) screws from the hard-drive cage.
3. Slide and remove the hard-drive cage out of the computer.
Removing and installing components 79