Dell 9200, Руководство пользователя

Страница: 85 / 174

Removing and Installing Parts
85
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you
apply equal force to each end of the module.
6
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
7
Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
8
Connect your computer and devices to electrical outlets, and then turn them on.
9
Right-click the My Computer icon, then click Properties .
10
Click the General tab.
11
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide .
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer.
1
Follow the procedures in "Before You Begin" on page 77.
2
Remove the computer cover (see "Removing the Computer Cover" on page 78).
3
Press out the securing clip at each end of the memory module connector.
4
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the
connector.
DIM_book.book Page 85 Monday, October 15, 2007 11:04 AM