Delem DAC-360, Руководство по установке, Страница: 30 / 82

V0208, 2.4
• one analog output signal.
The type of control can be specified as on-off control. When there is a position error, the
control signal is on. When there is no position error, the control signal is off.
• 1-speed AC axis
For a 1-speed axis, the parameter 'axis type' must be set to 1. This axis can be driven through
2 digital outputs or through the analog output.
2.c
For this axis, the parameter 'Brake point low speed' (BLS) must be programmed. This
parameter defines the switch-off points for the axis movement. The value depends on the
known deceleration rate of the axis equipment. If the BLS is not accurate enough to reach the
programmed position, the parameter 'Stop time' (T) can be used for further fine-tuning of the
positioning.
If the axis is controlled through the analog output, the parameter 'DC slow speed' must be
programmed to a correct value.
• 2-speed AC axis
For a 2-speed axis, the parameter 'axis type' must be set to 2. This axis can be driven through
3 or 4 digital outputs or through the analog output. The axis can be controlled at two different
speed levels.
2.d
For this axis, the parameters 'Brake point low speed' (BLS) and 'Brake point high speed'
(BHS) must be programmed. These parameters define the switch-off points for high and low