Delem DA-56, Справочное руководство

Страница: 95 / 126

Delem
V0505, 7.5
question the action will be aborted.
The machine number is also stored in the filenames of tools. When the machine number
is changed in this screen, you are prompted to make a new backup of your tools because
the filenames of all tools have been changed according to the new machine number.
Angle correction computation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MI =
Parameter to switch computation of angle corrections on or off.
When this parameter is set to enabled, the operator can enter the measured angle of a
bend and have angle corrections calculated.
With this parameter is set whether or not the field 'measured angle' is available in the cor-
rections window. See chapter 10 for more information about the corrections window.
Angle correction database . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CD =
Toggle function, to switch the database with angle corrections on or off.
Angle corrections are entered in production mode (automatic/step by step). These correc-
tions are stored in the product program. Beside this, it is also possible to store these cor-
rections in a general database with angle corrections. This way corrections that have
once been entered for certain bends remain available for future use in other products.
When this setting is switched on, the control checks during production whether correc-
tions for similar bends are present in the database. If corrections for certain bends are
available, then they will be offered. On other occasions, corrections can be interpolated
and offered.
The correction database is adjusted by entering new corrections during production.
When the database is enabled with this parameter, all new-entered corrections are stored
in the database.
When searching for similar bends, the control searches for bends that have the same
properties as the active bend. The following properties of a bend are compared:
- Material properties
- Thickness
- Die opening
- Die radius
- Punch radius
- Angle
The first five properties of a bend must be exactly the same as the active bend to start a
comparison. If the angle is the same as the angle of the active bend, the correction is
offered. If the angle of the active bend has a maximum difference of 10° with two adja-
cent bends, a correction is interpolated from these two bends. If the resulting correction
has a difference of more than 5° with one of the two other bends, there will be no correc-
tion offered.
Auto-computations edit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC
In the ‘data edit’ mode you can change the value of the programmed parameters. This
can also influence the value of other parameters. With this parameter you can choose to
have the other values automatically recomputed. Program ‘auto computations edit’ to 1.
There are three cases in which automatic computation can be used.
1. In case you change the value of the parameters ‘material type’ or ‘material thickness’