Delem DA-56, Справочное руководство

Страница: 49 / 126

Delem
V0505, 3.7
Note 1:
The flattening bends are shown here with a special flattening punch, but this is not required.
Note 2:
When bottoming operation is selected, the end of bend position of the Y-axis beam is depend-
ing on the working tonnage. If however the force is sufficient for the beam to go to the calcu-
lated Y-axis end of bend position, the beam stroke will be limited by the position value.
Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . BL
Length of plate between tools
Angle/Bendposition. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
α
/Y
Angle to bend or beamposition in mm if bottoming has been selected
Opening . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DY
This parameter results in a certain gap opening between the punch and the die after the
bend. A positive value is the gap opening above Mute, a negative value below Mute.
When you want to limit the handling time of the product you can program a small posi-
tive or a negative value.
Mute . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M
Sequence point at which the Y-axis is switched from fast closing speed to pressing speed.
The value programmed here is the distance of the mute point above the plate. By default,
the mute value from the programmed die is used.
Whether or not this parameter is present depends on machine settings.
Backgauge position. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . X
Backgauge position. When a negative sign is programmed this backgauge dimension is
an incremental dimension. The incremental dimension is subtracted from the actual X-
axis position. Therefore this parameter can also be used as a chaining measure.
Only in case you have a configuration with a R-axis.
The function key (‘gauge func’) appears when you put the cursor bar on this X-axis parameter.
flattening The sheet is folded in two. This is possible
after the sheet has been bent into a sharp
angle in a previous bend. The control calcu-
lates the precise Y-axis position for this
action: the surface of the die plus twice the
sheet thickness.
Y-axis positioning can be adjusted by pro-
gramming a 'flattening offset'.
flattening and
bottoming The same as flattening, but now the control
assumes the top of the die as required Y-axis
position. The folded sheet is squeezed
between punch and die.