Delem DA-56, Справочное руководство

Страница: 117 / 126

Delem
V0505, 9.3
• Parameters
BEND no . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . BN =
Selection of a bend of the program displayed on the monitor screen.
Corr
α
1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C
α
=
Corr
α
2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C
α
=
Corrections on angle values (C
α
) in this bending.
Angle corrections can be programmed for both sides of the machine, Y1 and Y2. When
correction
α
1 is entered for one side, this value is automatically copied to the
α
2 correc-
tion for the other side. The correction for the other side can then be changed. When both
angle corrections have been entered, the resulting corrections for Y-axis and parallellism
are calculated. The corrections will be saved in the active bending program.
The angle correction should be entered as following examples indicate:
1) Programmed value of 90 degrees.
Measured value of 92 degrees.
Then it is required to program Corr.
α
with -2.
2) Programmed value of 90 degrees.
Measured value of 88 degrees.
Then it is required to program Corr.
α
with +2.
In case the angle correction database has been switched on, the control checks whether a cor-
rection exists for this type of bend in the database. The result of this check is prompted in the
entry field:
No stored correction. No correction has been found for this bend
Stored correction. A correction that matches the current bend has been found
Interpolated correction. A correction has been calculated (interpolated) based on other exist-
aux. axes Switch to second view with parameters of auxiliary
axes.
view bends Switch to a table view in which all bends are shown.
graphical
vis Switch to graphical visualisation of the program.
zoomed
values Switch to view with axes values.
view notes Open a window with notes about the current product.
Function keys: