Delem DA-56, Справочное руководство

Страница: 57 / 126

Delem
V0505, 3.15
When in, for example, the 1st bend the plate must rest on the backgauge finger, see table below
for programming values.
• List of bendings of the prepared program
Pressing this softkey in the data editing mode will result in a complete overview of the bend-
ings programmed. After pushing END the page will be restored from which this page was
selected, with the cursor on the parameter selected before.
3.m
A specific bend can be selected on the screen by putting the highlighted bar on that bend, then
pressing END.
The view is split in two parts. At the top of the parameter screen, the general parameters of the
product are shown. In the main section of the screen, the bend parameters are shown in a
spreadsheet view.
From within this screen, the complete CNC program can be edited. All bend parameters can be
edited within the spreadsheet and bends can be swapped, moved, added and deleted.
Bend Angle (AN) Backgauge (XN)
1 1 100
2 4 5
3 3 1
4 2 1