17
SENSOR
SE
NS
OR
SE
NS
OR
4
5
6
3x
A
y
Loosen the screws
4
.
y
Remove the mounting ring
5
.
Fig. 8
Removing the mounting ring
y
Read the instructions for use and the safety datasheet for the adhesive.
y
Apply a thin layer of the supplied adhesive to the hollow on the rear of the
mounting ring (surface A).
y
Within 6 minutes, affix surface A of the mounting ring to the marked position in
the swimming pool. Align the cable slot
6
in the desired direction.
y
Do not apply any loads to the mounting ring for 24 hours.
Caution!
Incorrect fitting of the pool sensor will prevent proper monitoring of
the swimming pool. The side of the pool sensor marked "Sensor"
must face into the swimming pool (water).
SENSOR
SE
NS
OR
SE
NS
OR
8
7
3x
"Sensor"
6
y
After a minimum of 24 hours
y
Push the pool sensor into the
mounting ring
7
(route the pool
sensor cable through the slot in the
mounting ring
6
).
y
Tighten the screws using only slight
force
8
.
Fig. 9
Fitting the pool sensor into the mounting ring
y
Affix the pool sensor cable.
y
Test the system, see
Testing active mode, P. 28.
