dbx DriveRack 260, Руководство пользователя

Страница: 69 / 70

DriveRack
®
DriveRack® 260 User Manual
67
Appendix
Appendix
attenuators does not change the potential output of the amplifier; it only requires more input voltage to get full output
power. Many amplifiers will clip with an input level greater than +6 dBu when the input attenuators are turned all the
way up. Most mixing consoles can deliver over +18 dBu of output level before clipping. This means that with your amps
tuned all the way up you are sacrificing 12 dB of headroom, resulting in poorer noise performance and the potential of
system clipping. By adjusting the amplifier controls properly, you can maximize your system performance.
A way to set up your amplifiers for maximum gain structure is to use the clip indicators of the console and amplifiers
themselves. Disconnect the output of the amplifier from the speakers. Run a continuous signal (pink noise or sine
waves – many test CDs are available that have these types of signals) through your console. Turn up the output of the
console until it begins clipping. If there is no clip indicator on the console then use the output meters; most reputable
console manufacturers use red LEDs at the top of the meters to show the onset of clipping. Once the console is clipping,
back the output gain down slightly until the clip indicator turns off. Run this signal through the DriveRack 260 and into
the amplifiers with the crossovers and output gain section in the DriveRack 260 set for your particular speakers. Make
sure that the output limiters are turned off. Run this signal into the amplifiers and turn up the input attenuators until
the amplifier clip indicator begins to turn on. Turn the attenuators down slightly, so the clip indicator no longer is on.
You have just maximized the gain through your system. This amplifier setting should give you maximum gain without
clipping, another way of say this is that when the output of your console is clipping you will also be at the clip point of
your amplifiers.
Once you have found the clip point of your amplifiers, you can mark this position and turn the amplifiers back up to
the point where they are clipping. You can now use the output limiters in the DriveRack 260 to protect the amplifier
from clipping no matter what you do at the console. With the amplifiers clipping, now go to the Limiter page of the
DriveRack 260 and turn the limiter for each output band on. Make sure that the threshold is all the way up to +20dB.
Now slowly reduce the threshold until the clip indicator of the amplifier turns off. You have successfully set the output
limiter up and the amplifier will not be able to go into clipping no matter what the input is. You should now proceed to
the next output band and go through the same process. If you are using a sine wave to create clipping in your amplifier
you should make sure that the sine wave is within the frequency range of the output band that your are working
with. Once all the limiters are set up you can now turn the amplifiers back down to the gain maximized position. The
Wizard will automatically set your limiters based on your choice of amplifier. Because of component variances within
the amplifier circuitry, you may need to adjust the limiter settings by a few dB after running the Wizard to ensure that
they are set correctly. Once all the limiters are set up and the gain is maximized, reduce the output of your console and
reconnect your speakers. Now for the fun part, sit back and send your favorite music through the system. If your system
is not loud enough, you may want to consider an amplifier or amplifiers with greater output power. Most loudspeaker
manufacturers recommend an amplifier that can provide 1.5 to 2 times the rated RMS power of the speaker. If this setting
is too loud when your speakers are reconnected you can turn down the amplifier input attenuators even more.