DAYGAS Radium 15, Руководство пользователя и гарантия

Страница: 23 / 34

Commissioning Procedure
CAUTION! Before connecting the emitter to the gas pipeline, the inner surface
of the gas pipeline must be cleaned. The gas supply valve to the emitter must
be closed while testing the strength, tightness and control pressure of the gas
pipeline, otherwise this may damage the valve block.
» Check the gas pressure in front of the heater. The gas pressure must comply with
the value specified in the paragraphs.
»
Check the operation of the boiler and the ignition electrode of the heater and
whether there is a spark.
Attention! If the emitter does not start within 30 seconds, the gas supply to the
emitter is cut off. To restart the transmitter, you must turn off the transmitter’s
power supply.
» Connect the power cable to the transmitter via an external disconnect device.
Grounding is required.
»
Connect the heater to the gas pipeline. Open the gas valve in front of the absorb-
er and check the tightness of the gas pipeline and the threaded connections of
the emitter (after the gas valve) with a soapy solution at the rated gas pressure.
Eliminate gas leaks when detected.
»
Check the gas pressure in front of the heater. The gas pressure must comply with
the value specified in the paragraphs.
»
Check the operation of the boiler and the ignition electrode of the heater and
whether there is a spark.
23
www.daygas.eu