DAYGAS Radium 15, Руководство пользователя и гарантия

Страница: 10 / 34

Gas Valve
Setting Procedure
»
Turn on the gas supply and power supply to the device.
» Make sure that the gas valve is at least 21 mbar.
» Loosen the screw at the gas outlet pressure measurement point on the gas
valve of the device.
»
Connect the manometer to the nipple using a rubber or PVC pipe.
»
Measure the gas outlet pressure of the valve block.
» The pressure setting of the 1st stage is increased by turning it clockwise with
a Phillips screwdriver from the point shown in Figure 1, and the pressure is
decreased by turning it counterclockwise.
»
The pressure setting of the largest step is increased by turning it clockwise
with the ten socket wrench from the point shown in Figure 1, and it is decreased
by turning it counterclockwise.
» Make sure that the gas pressure at the burner nozzle inlet changes by slowly
turning the screw of the adjustment pressure regulator to the right and left.
»
The pressure setting of the device is adjusted according to the data on the
information label.
» After the gas pressure adjustment is made, disconnect the manometer from
the nipple.
»
Be sure to tighten the screw inside the nipple well.
»
After tightening the screw, check its tightness with a soapy solution.
RADIUM PIPE PARTS
Ignition electrode (Lighter)
Injector
Gas injector nut
Gas burner interior
Gas burner external flanged
Procestat
Procestat tube double
Prosestat cable line
Procestat hose holder
Snail fan
Snail fan cable line
C-14 socket
Glass fuse
Motherboard box
Motherboard
Gas flex (internal)
Remote control
Power cord
Lighter cap
I reflective aluminum 3m
I hanger clamp
I hanger clamp spring
Flue adapter
I radiant tube 6m
I radiant pipe clamp (coupling)
3/4 gasket
I side closure double
U type reflector
U side closure double
U elbow
U hanger
Tors screw
10
www.daygas.eu