Daum electronic 8008 TRS, Руководство пользователя

Страница: 91 / 110

M 12
7b
7e
7
4.1
6
X
HS
CS
HK2
HK2
HK1
HK1
3
8a
H/J
H/J
6a
E
A
B.2
B.1
H/J
H/J
3
6
5
6x
3
Description
After plugging the cable connectors in the rear side
of the dashboard, raise the dashboard holder (6)
all the way up. Align carefully the dashboard cable (3)
and the cables(HK1 & HK2) very closely along the clamp (8.1)
in the area of the inner ridge of the holder end (6).
5.
5
5.
6
5.
7
The dashboard holder (6) is attached to the dashboard
housing (4.1) by pressing the clip on the front.
Then you
must ensure that both of the hand pulse cables run
freely around the handle (7) and the clamp (8.1), and
are not jammed between the carrier plate (5) and
the dashboard holder (6),
before you can screw two
small self-boring screws (H) with washers (J) through
the protective plate (5) into the dashboard housing (4.1).
Otherwise, there is a risk of cutting the cables if
the handle or handle add-on is turned.
Finally, screw the tensing lever (6a) with its washer (E)
to fasten the handle (7). You should always tighten it
slowly, and always respect the lock-positions. Removing
the preassembled dashboard unit is done in the reverse
sequence as described above.
5.
4
Please pay extra attention to avoid jamming the cables
in the narrow passages within the dashboard holder!
Pull the hand pulse cables (HK1/HK2) closely along
the triathlon set holder (7e) down to the handle tube (7),
and from there through the lateral opening in the housing.
Dashboard angle setting / Articulated joint A
Angle setting of articulated joint
Racing handle (7) B.1
Triathlon add-on set (7b) B.2 /
C
Fine adjusments
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Articulated joint A
Articulated joint C
Cables HK1 & HK2
Pull the cables
lateraly
out of the opening
in the handle tube
HK1 & HK2
should not be
jammed
between the
carrier plate (5)
and
the dashboard
holder (6)!
The inner ring (6x) should be pressed into the holder (6)
from below. The cable (3) will have enough room between
the handle column (2) and the inner ring (6x).
Assembly