73
To load your own logo, replace the LOGO1 or LOGO2 bmp files, which are stored on the SD Card. The files
you create need to be 128 x 96 pixels. Name your files logo1.bmp and logo2.bmp as these are the only
names that will be recognised.
Load the SD Card into the slot on the Remote Control Card, and fit the card into Slot 15 of the base Unit
Go to option 11. COPY LOGO FILE of the Logo Setting Menu and select which logo you want to load;
LOGO1 or LOGO2. Once you’ve selected the logo press the Reset Key, and the SE-900 will upload the new
logo.
Press the LOGO Key and the new logo will be shown in place of the old logo.
Luma Keying with Logo Function
With the SE-900 you can Luma Key in two ways, either with the Logo function or with the Chroma Key
function. (You need to install the Chroma Key board to use the Chroma Key function).
The Luma Key using the Chroma Key more is more flexible however it is possible to get a good key using
the Logo Function.
The benefit of using the Logo Function for Luma Keying is that you can still use the SE-900 as a vision
mixer, or even use the Chroma Key in combination it with the Luma Key.
In the Logo Function Set Up Menu set 1. SOURCE to the channel that you want to key. You can select any
channel 1 ~ 8; it would normally be a DVI / VGA channel, or maybe a SDI channel, but the choice is yours.
