Datavideo SE-1200MU, Инструкция по эксплуатации

Страница: 14 / 60

14
Instructions
1. First connect the router to the SE-1200 MU and the Windows computer using two RJ-45 patch leads.
2. Turn on the Windows computer and set it to DHCP setup within the Windows Network and Sharing
Centre .
3. Now click the Windows start button and run the CMD prompt window.
4. At the command line > : _ type IPCONFIG and press enter.
5. The DEFAULT GATEWAY number displayed should be the router’s current IP address.
6. Enter the DEFAULT GATEWAY IP address into the address bar of the computer’s web browser.
7. The web browser should display the login window for the router. Enter the router’s login and/or
password.
The login details may be written on a sticker on the router itself or noted in the manual for the router.
8. Once logged into the router we need to change the router to supply IP addresses in the
192.168.100.xxx range. Use the router’s LAN Setup or Configure LAN option to set the router’s IP
address as
192.168.100.1
and click
save / apply
.
9. Now reboot the router and power ON the SE-1200 MU.
10. Log into the router again using the web browser and the router’s new IP address 192.168.100.1
11. Use the router’s LAN Setup or Configure LAN option again, within this option there should be another
option called
Address Reservation
or
Client List
.
12. The two devices connected to the router should be listed here, the computer and the SE-1200 MU.
13. The computer, because it is set for DHCP, will already have an IP address automatically assigned to it in
this list.
14. The SE-1200 MU may only show its MAC address
(1E:ED:19:27:1A:B3)
. Copy and Paste the SE-1200
MU’s MAC address into the MAC address reservation box. Now enter the following IP address
192.168.100.101 into the reservation box next to the SE-1200 MU’s MAC address.
15. The router should now give the IP address 192.168.100.101 to the SE-1200 MU when it is connected to
the router.
16. Click
save / apply
then reboot the router again.
17. Close the web browser and CMD windows.
18. Now install the supplied SE-1200 MU control software to the computer.
3.2.2 How to control the SE-1200 MU from another building or city
Once you are familiar with the SE-1200 MU you may want to control the switcher from another building or
even a different city. This requires certain internet and network access that may not already be present at
both sites.
Note: It is best to discuss your planned SE-1200 MU set up beforehand with your local I.T. or network
support manager as this process will involve ‘opening’ or ‘forwarding’ TCP/IP ports.
To create this dedicated SE-1200 MU IP set up you will need:
•
Two sites with internet access. We will call these site A and site B.
• Site A will have the same SE-1200 MU set up as Section 3.1 but with no local computer connected.
•
Site B will have a Windows 7/8 computer connected to the internet with VLC Player and the
Controller software.
• Port 5000 will allow streaming of the SE-1200 MU multi view from site A to VLC Player at site B.