iBoot-PDU_v170515e
iBoot-PDU User Manual
Page 31
Remote Settings
7.4.2.
IP Address
Set the IP Address in format XXX.XXX.XXX.XXX
Username
Set the username for the remote unit. The username used must have
administrative rights. Only outlets to which the username used has rights to will
be managed by this iBoot-PDU.
Password
Set the password associated with the username above.
Delay
Sets the Delay Time for the remote unit. Sets the time, in seconds between
powering each outlet when multiple outlets are being turned on. Minimizes inrush
current issues.
Click Save to complete the setup and initiate communication with the remote.
Remote Administration
7.4.3.
The iBoot-PDU will connect with the remote unit and present Up, Down or Pending status in the upper right
corner of the remote unit’s card. This same status appears on the device card on the dashboard, if the Show
on Dashboard selector is checked.
7.5.
IP Address
The IP Address card shows the current IP Address setup and allows changing of theses parameters. The
iBoot-PDU allows for these setting to be manually entered or assigned from a DHCP server. Check with your
network administrator for the proper configuration and settings.
IP Address Settings
7.5.1.
IP Mode
Sets the mode that will select the IP Address settings:
DHCP: The iBoot-PDU will get these settings from a DHCP Server
STATIC: The iBoot-PDU will used the settings as manually set below:
IP Address
Enter the IP Address [XXX.XXX.XXX.XXX]
Subnet Mask
Enter the Subnet Mask [XXX.XXX.XXX.XXX]
