Data Flow Systems TCU800, Быстрый старт

Страница: 19 / 25

18
Modbus Derived Flow Pump Monitoring
Protocol Well Volume THERM Function
Baud Flow Units THERM Alarm On
H Address SEAL Function
H Length SEAL Alarm On
I Address Analog 3 Type
I Length Analog 4 Type
J Address
J Length
K Address
K Length
L Address
L Length
M Address
M Length
N Address
N Length
O Address
O Length
* This setting is used in
development and should not
be changed.
Auto-Configuring
At this time, using a TCU001 PLC configuration will cause an error in the TCU800. To avoid this, first
transfer the existing configuration of the TCU800 using HT4 PLC editor. Then save the .plc file, create an
auto-config file, and upload it to the appropriate station you want to auto-config.
Remote Configuration Changes
Changing configuration values using the PLC editor is supported but requires that the settings be transferred
initially from the TCU800 (once). If taking this step, disregard the configuration values listed in the
Autodialer section of the editor as the TCU800 does not support Autodialer and the settings have been
repurposed for other use. This workaround is temporary. If only changing a few configuration values, this
step can be bypassed as only the changed values need to be selected and sent.
Advanced Settings
Auto-config
Request station configuration from HSS. Must have a
TCU800 auto-config file uploaded to server using
HT3/HT4 for the correct station address.
Factory Reset Returns TCU800 to the factory default configuration.