Dannmar DLR-6, Инструкция по установке и эксплуатации

Страница: 29 / 40

DLR-6/6P Low-Rise Scissor Lifts
29
P/N 5900254 — Rev. A — September 2020
Moving the Lift (DLR-6P only)
The DLR-6P is portable; you can move it between locations as needed.
⚠
DANGER Do
not
move the Lift or perform any maintenance to the Lift without first confirming
that electrical power has been disconnected and cannot be re-energized.
To move the Lift :
1. Make sure the Lift is fully lowered, then disconnect the Quick-Connect Fittings.
⚠
WARNING
Do not attempt to connect or disconnect the Hydraulic Hoses while equipment is
loaded or while the Hydraulic System is under pressure.
2. Pull up the Wheel Assembly Handle and flip down the Wheel Pin.
3. Using the Tow Cart, hook the Tow Pin into the Latch near the bottom of the Frame.
4. Using a downward force, push the Tow Cart to raise the Lift onto its rear wheels, and then carefully
move the Lift to the desired location.
5. Remove the Tow Cart and lower the Wheel Assemblies.
⚠
WARNING Do not operate the Lift with the Wheel Assemblies in the down position.
Maintenance
⚠
DANGER Before performing any maintenance, make sure the Lift is completely disconnected
from power and
cannot
be re-energized until all maintenance is complete. We
strongly recommend using your Power Disconnect Switch during maintenance. If
your organization has Lockout/Tagout policies, make sure to implement them
during all maintenance.
To maintain your Lift :
• Daily : Keep the Lift clean. Wipe up any oil spills, clean any dirt.
• Daily : Make a visual inspection of all moving parts and check for damage or excessive wear. If
you find any damaged or worn parts, take the Lift out of service until they are replaced.
• Daily : Make sure the Safety Locks are in good operating condition. If you find that the Safety
Locks are damaged or excessively worn, take the Lift out of service until they are replaced.
Do
not use your Lift if the Safety Locks are damaged or excessively worn .
•
Weekly
: Check all controls to make sure they are functioning normally.
• Weekly : Check all labels on the unit. Replace them if they are illegible or missing.
• Monthly : Lubricate the grease fittings. We recommend using white lithium grease or similar.
• Monthly : Check the Power Unit’s Hydraulic Fluid levels. Refill if low.
• Every two months : Check all Anchor Bolts to make sure they are tight. If not, tighten them.
⚠
WARNING:
Do not operate your Lift if you find issues; instead, take the Lift out of service,
then contact your dealer, visit
dannmar.com/support , email
support@dannmar.com or call (877) 432-6627 .