Dannmar DLR-6, Инструкция по установке и эксплуатации

Страница: 22 / 40

DLR-6/6P Low-Rise Scissor Lifts
22
P/N 5900254 — Rev. A — September 2020
Reconfigure the Power Unit to 230 VAC (optional)
The Power Unit comes fully assembled from the factory, configured for 115 VAC operation. To use the
Power Unit with 230 VAC power, you need to reconfigure it.
⚠
DANGER Reconfiguring the Power Unit to use 230 VAC power requires a licensed, certified
Electrician. Attempting to reconfigure your Power Unit without using an Electrician
voids your warranty and puts everyone who uses the Lift in danger.
The Power Unit for the Lift is 115 VAC or 230 VAC, 50/60 Hz, 1 phase.
Additional important electrical information:
• Improper electrical installation can damage the Power Unit motor; this damage is
not
covered
by the warranty.
• The Power Unit must not get wet. Never expose the Power Unit to wet or damp conditions.
Damage to the Power Unit caused by moisture is not covered under warranty.
• Protect each circuit with a time-delay fuse or circuit breaker. For a 230 VAC, 1 phase circuit,
use a 25 amp or greater fuse.
• The Lift uses electrical energy; if your organization has Lockout/Tagout policies, make sure to
implement them once the unit is connected to a power source.
• The Power Unit’s motor is not thermally protected.
⚠
DANGER Do not begin to reconfigure the Power Unit to use 230 VAC power without first
making sure electrical power is disconnected from the Lift and
cannot
be
re-energized until the procedure is complete.
To reconfigure the Power Unit to use 230 VAC power :
1. Find the Power Cord; cut off the 115 VAC plug that comes with the unit.
2. Wire a 230 VAC plug to the end of the Power Cord.
Refer to
Wiring Diagrams
for wiring information.
You can also take off the Electrical Panel Cover (around the Raise button); wiring information is on
the inside of the Cover.
3. Plug the Power Cord in to a grounded 230 VAC outlet.