Danfoss vlt soft starter mcd 500, Инструкция по эксплуатации

Страница: 55 / 95

7 Programming
You can access the programming menus at any time, including while the soft starter is running. All changes take effect immediately.
7.2 Access Control
Critical parameters (parameter group 15 and higher) are protected by a four-digit security access code, preventing unauthorised users from viewing or
modifying parameter settings.
When a user attempts to enter a restricted parameter group, the LCP prompts for an access code. The access code is requested once for the programming
session, and authorisation continues until the user closes the menu.
To enter the access code, use the BACK and OK buttons to select a digit, and the
▲
and
▼
buttons to change the value. When all four digits match your
access code, press OK . The LCP will display an acknowledgement message before continuing.
To change the access code, use par. 15-1.
Enter Access Code
####
OK
Access Allowed
SUPERVISOR
NB!
The simulation tools and counter resets are also protected by the security access code.
The default access code is 0000.
You can lock the menus to prevent users from altering parameter settings. The adjustment lock can be set to allow Read & Write, Read Only or No Access
using Par. 15-2.
If a user attempts to change a parameter value or access the Main Menu when the adjustment lock is active, an error message is displayed:
Access Denied
Adj Lock is On
MCD 500 Operating Instruction 7 Programming
MG.17.K2.02 - VLT
®
is a registered Danfoss trademark
55
7