Danfoss MCB 113, Руководство по эксплуатации, Страница: 41 / 54

Option Function
[84] SL digital output E See parameter 13-52 SL Controller Action . The output goes high whenever the smart logic action [42]
Set dig. out. A high is executed. The output goes low whenever the smart logic action [36] Set dig. out.
A low is executed.
[85] SL digital output F See parameter 13-52 SL Controller Action . The output goes high whenever the smart logic action [43]
Set dig. out. A high is executed. The output goes low whenever the smart logic action [37] Set dig. out.
A low is executed.
[120] Local ref active The output is high when parameter 3-13 Reference Site = [2] Local or when parameter 3-13 Reference
Site 0 [0] Linked to hand auto at the time as the LCP is in hand-on mode.
1
The numbers in the [ ] positioned after the relay nummbers are the index values in the parameter.
Table 28: Local Reference Active
Reference site in parameter 3-13 Reference Site Local reference active [120] Remote reference active [121]
Reference site: Local
parameter 3-13 Reference Site , [2] Local
1 0
Reference site: Remote
Parameter 3-13 Reference Site , [1] Remote
0 1
Reference site: Linked to hand/auto
Hand 1 0
Hand
⇒
off 1 0
Auto
⇒
off 0 0
Auto 0 1
Table 29: Parameter 5-40 Relays - 2
Option Function
[121] Remote ref active Output is high when parameter 3-13 Reference Site = [1] Remote or [0] Linked to hand/auto while
the LCP is in auto-on mode. See table 28 .
[122] No alarm The output is high when no alarm is present.
[123] Start command active Output is high when the start command is high (that is via digital input, bus connection, [Hand
On], or [Auto On]), and a stop has been last command.
[124] Running reverse Output is high when the drive is running counterclockwise (the logical product of the status bits
running AND reverse ).
[125] Drive in hand mode Output is high when the drive is in hand-on mode (the LED above [Hand On] is lit).
[126] Drive in auto mod Output is high when the drive is in auto-on mode (the LED above [Auto On] is lit).
[151] ATEX ETR cur. alarm Selectable if parameter 1-90 Motor Thermal Protection is set to [20] ATEX ETR or [21] Advanced ETR .
If alarm 164, ATEX ETR cur.lim.alarm is active, the output is 1.
[152] ATEX ETR freq. alarm Selectable if parameter 1-90 Motor Thermal Protection is set to [20] ATEX ETR or [21] Advanced ETR .
If alarm 166, ATEX ETR freq.lim.alarm is active, the output is 1.
Parameter Setup
Operating Guide | VLT® Extended Relay Card MCB 113
AQ322553864968en-000101 / 130R0353| 41
Danfoss A/S © 2020.01