Option
Function
[38]
Motor feedback er-
ror
[40]
Out of ref range
Active when the actual speed is outside settings in
parameter 4-52 Warning Speed Low
in
parameter
4-55 Warning Reference High
.
[41]
Below reference,
low
Active when the actual speed is below speed reference setting.
[42]
Above ref, high
Active when the actual speed is above speed reference setting.
[43]
Extended PID limit
[45]
Bus ctrl.
Controls output via bus. The state of the output is set in
parameter 5-90 Digital & Relay Bus Control
. If
a bus timeout occurs, the output state is retained.
[46]
Bus ctrl, 1 if timeout
Controls output via bus. The state of the output is set in
parameter 5-90 Digital & Relay Bus Control
. If
a bus timeout occurs, the output state is set high (on).
[47]
Bus ctrl, 0 is time-
out
Controls output via bus. The state of the output is set in
parameter 5-90 Digital & Relay Bus Control
. If
a bus timeout occurs, the output state is set low (off).
[50]
On reference
Active when a VLT® Cascade Controller MCO 102 or VLT® Motion Control MCO 305 is connected. The
output is controlled from the option.
[51]
MCO controlled
Active when a VLT® Advanced Cascade Controller MCO 102 or VLT® Motion Control MCO 305 is con-
nected. The output is controlled from the option.
[54]
24V encoder sim
Digital outputs 27 and 29 simulate a single-signal HTL encoder. Select source for the signal genera-
tion in
parameter 5-78 Term 27/29 Encoder Sim
.
NOTICE
Option
[54] 24V encoder sim
must be selected in both
parameter 5-30 Terminal 27 Digital Out-
put
and
parameter 5-31 Terminal 29 Digital Output
. This option is only available for software
version 48.xx for VLT® AutomationDrive FC 302.
[55]
Pulse output
[58]
Actual position
[59]
Actual position 4–
20 mA
[60]
Comparator 0
See
parameter group 13-1* Comparators
. If comparator 0 is evaluated as true, the output goes high.
Otherwise, it is low.
[61]
Comparator 1
See
parameter group 13-1* Comparators
. If comparator 1 is evaluated as true, the output goes high.
Otherwise, it is low.
[62]
Comparator 2
See
parameter group 13-1* Comparators
. If comparator 2 is evaluated as true, the output goes high.
Otherwise, it is low.
[63]
Comparator 3
See
parameter group 13-1* Comparators
. If comparator 3 is evaluated as true, the output goes high.
Otherwise, it is low.
[64]
Comparator 4
See
parameter group 13-1* Comparators
. If comparator 4 is evaluated as true, the output goes high.
Otherwise, it is low.
[65]
Comparator 5
See
parameter group 13-1* Comparators
. If comparator 5 is evaluated as true, the output goes high.
Otherwise, it is low.
Parameter Setup
Operating Guide | VLT® Extended Relay Card MCB 113
AQ322553864968en-000101 / 130R0353
34 | Danfoss A/S © 2020.01