Vision manual page:11
3.4 Channel assign / fader section
The
Channel assign
section allows the user to assign to a maximum of 4 busses. The routing gives selection
to the 4 group modules using two pushbuttons. With ach pair of summing amps, you have the choice of
assigning to the odd or even groups using the pan-pot.
The
L/R
switch (in the assign section) assigns the pan-pot to the stereo mix buss while the pan control
pans the signal between the main stereo mix L / R busses and / or the odd and even group summing busses if
assigned.
The Vision's summing amp and internal structure means that it is extremely quiet and distortion free,
therefore a direct button to bypass the amps is not necessary.
The MUTE switch is a momentary switch that controls a silent FET switch to mute the channel.
The FET can also be controlled by the optional MIDI mute module.
The
SOLO
switch has two modes, pfl (pre fade listen) or a non-destructive stereo solo-in-place system.
Master status switching (located in the master section) selects the solo in-place or PFL mode for the entire
console. Activating the solo switch in the pfl mode will send the pre-fader signal to the CRM speakers. In the
solo in-place mode, the post monitor pan-pot signal is heard. A solo indicator LED is fitted next to the solo
switch.
Fader section
The Vision has a high quality 100mm fader. Alps or P&G faders are optionally available. You can use any VCA
Mix Automation System which uses the faders and mute system in the Vision. The channels are prewired for
accepting any VCA automation system.
