Vision manual page:22
The led bar is a peak reading 6 segment led bar following as a factory preset the post equalizer signal, thus
indicating the incoming signal .The led bar can be set Post channel indicating the direct output level post
fader.
Note: This peak reading device indicates a -6 dB reading below actual level with a steady sinus tone. So when
the internal level is 0 dBu, the meter will indicate -6 dB (The -3 dB led is on, the -10dB led is off)
6.6 Fader section
The Vision has a high quality 100mm fader. Alps or P&G faders are optionally available. You can use any VCA
Mix Automation System which uses the faders and mute system in the Vision. The channels are prewired for
accepting any VCA automation system.
6.7 In/output section
Every stereo channel has the following connectors at the back of the housing.
The balanced
LINE LEFT-A
input is a stereo 1/4" jack socket:
Tip = hot
Ring = cold
Sleeve = shield
The balanced
LINE RIGHT-A
input is a stereo 1/4" jack socket:
Tip = hot
Ring = cold
Sleeve = shield
The balanced
LINE LEFT-B
input is a stereo 1/4" jack socket:
Tip = hot/RIAA
Ring = cold/Ground Sleeve = shield
The balanced
LINE RIGHT-B
input is a stereo 1/4" jack socket:
Tip = hot/RIAA
Ring = cold/Ground
5.0 Optional Patchbay - description
6.8 Jumper/connector information
J3/12= LEDBAR INP SELECT LEFT
1/2=Left POST CHAN FADER
3/4=POST EQ Left (pre-insert)
J5=Power connector RIAA pcb
pin1=+Vs
pin2/3=Ground Pin4=-Vs
J7=Aux3/4
pre/post
select
pin1/2=post
pin3/4=pre
J8=Aux5/6
pre/post
select
pin1/2=post
pin3/4=pre
J9=Aux7/8
pre/post
select
pin1/2=post
pin3/4=pre
J14= Midi mute connector
1=Read
2=Write
J 17=Remote connector
pin1=tip
pin2=ring
pin3=sleeve
J1 8=RIAA in/out connector
Pin1=line B right input
Pin2=line B right output
Pin3=Line B left input
Pin4=Line B left output
