Dando DUKE STAGE IV, Руководство по эксплуатации и техническому обслуживанию, Страница: 54 / 400

FIGURE 3.26
2. To stow the SPT Auto Hammer wind the winch up using the tooling
winch (Control M, Figure 3.3) until the locking bracket fabrication lugs are
over the top stowage fabrication slots. (The tooling winch can be adjusted to
get the lugs close to the slots. See 3.27 for recommended height, indicated
by red line).
FIGURE 3.27
3.
Lower the tooling winch until the locking bracket fabrication lugs on the
SPT Auto Hammer locate in the top stowage fabrication slots of the mast.
The tool winch should be lowered until the top section of the auto hammer is
resting against the mast and the tool winch cable is slack (Figure 3.28).
48