DANA TM4 SUMO MD MV, Руководство по устранению неисправностей

Страница: 145 / 182

145
Service Codes
TT34: VMU Command Out-of-Range or Invalid
Description
The Troubleshooting Tree 34 indicates an error where
the command from the VMU is either out of range or
is an invalid command.
The command did not match what was required by the
CAN protocol.
The CAN network might cause the issue fixed. Refer
to the CAN protocol document published on the Dana
TM4 extranet site.
Note: Refer to the CAN protocol document as
published on the Dana TM4 extranet site.
To correctly diagnose the faulty system, connect the
Diagnostic Tool (see «Diagnostics» section for test
equipment and descriptions) and follow the
troubleshooting tree procedure below.
See “Safety Warnings” and “Troubleshooting Tips”
sections for general guidelines on system diagnostics.
System Mode
Referred by
SysFile ID
Condition Possible Causes
Operational
0x4001 0x4002
0x4003 0x4004
0x4005 0x4006
0x4007 0x4008
0x4009 0x400A
0x400B 0x400C
0x400D 0x400E
0x400F 0x4010
0x4011
VMU command is out of
range or is invalid. 1.
Verify MCU CAN protocol document for
protocol requirements.