DANA TM4 SUMO MD MV, Руководство по устранению неисправностей

Страница: 51 / 182

51
Service Codes
TT05: Hardware Failure Detected
Description
The Troubleshooting Tree 05 indicates that there is a
hardware error that may cause the system to go to
defective mode, whereby it will cease operation.
Components that may be the cause of the error are:
1. Motor Temperature sensors,
2. Resolver Chip,
3. Motor position sensor.
The resistance measurements of the resistance
values of the related
“Machine Internal Resistances”
may not be aligned as per Machine internal resistance
measurement table. The motor should be considered
defective.
The loss of integrity of the motor sensor connector on
the MCU leads to consider defective MCU.
Note : If the motor is a TM4 machine, then the
expected values of the measurements should be
between 10 Ohm and 5 kOhm. If the motor is not a
TM4 machine, then the measurements may be
different and refer to your machine specification.
Note : Refer to the TM4 motor installation guide for
more details on installation and deinstallation
procedure including safety warning considerations.
To correctly diagnose the faulty system, connect the
Diagnostic Tool (see «Diagnostics» section for test
equipment and descriptions) and follow the
troubleshooting tree procedure below.
See “Safety Warnings” and “Troubleshooting Tips”
sections
for general guidelines on system
diagnostics.
System Mode Referred by SysFile ID Condition Possible Causes
Defective
0x0315 0x0316 0x0321
0x0322 0x0323 0x0324
0x0325 0x0326 0x2200
0x3109 0x3400 0x3401
0x3402 0x3403 0x3404
0x3406 0x34070x3408
0x3500 0x4801 0x4B00
0x4B01 0X4B02 0x4B03
Internal
hardware fault
detection.
1.
Some foreign material within the MCU or
motor connector short some signals.
2.
MCU or motor connector pin is bent or
broken.
3.
Motor sensor cable defective.
4.
Defective motor.
5.
Defective MCU.