Dake Euromatic 370 S, Инструкция по эксплуатации

Страница: 35 / 64

370 S 370 S L 370 PP 370 PP L
35
Gear Box- 80 / 90 Gear Oil Way Oiler-Light Weight Way Oil
Air Oiler - Tool Oil Clean DRO Strip-Clean Dry Rag
EUROMATIC 370 PP / S MAINTENANCE SCHEDULE
NON-FERROUS HEAD
370PP/S
A
Gear boxThe gear box does not require any oil. The horizontal spindle shaft has zerk fittings provided for
lubrication. The spindle should be greased with a high quality, high temperature grease.
B Air oiler Located on the air regulator
must be dry and clean. Use appropriate measures to insure, before it
enters the machine.
C Head feed cylinder. The oil reservoir is mounted into the cylinder. The reservoir is clear and you can visually
inspect the amount. When oil level is approximately depth of 1/4” oil must be added
To fill reservoir remove brass cap on top and add oil into the reservoir until full Cycle head to bleed.
D Chip drawer Located behind front access doorThis drawer pulls easily out for cleaning. If a chip collection unit has
been installed to the back of the machine, it should be emptied at regular intervals.
E Coolant pan is located under chip drawer. The coolant should be kept clean. When coolant needs changing, remove
the drain plug from the pan.
F Way Oiler. This reservoir is on the back of the column. This reservoir should be kept topped off. At the beginning of
each shift, this should be pumped twice to maintain good lubrication for the ways.
G Gib blocks. This acts as an adjustable guide for the gear box. If adjustment is needed see the gib block adjustment
section in this manual
H Vise gib can be adjusted by loosening the lock nuts and turning the set screws equally. This should be done when
ever vise shifts left or right when clamping.
I clean frequently any chips that build up within the vertical column.
J Belt tensioning should be done as needed.
BELT TENSION ADJUSTMENT
A: To adjust loosen the four motor mounting bolts. (Loosen slightly)
B: Using the adjusting bolt threaded into the block on the motor panel (H) adjust as needed.
C: Tighten motor mounting bolts securely.
Note: If you find no adjustment left in the threads, the belt may be stretched and in need of replacement. Belt tension
should have approx. 1/4 - 3/8” deflection.
On occasion if adjustment is not possible, loosen the motor mounting bolt and reposition the motor and try adjustment.
Maintenance Schedule
Item Model Daily Weekly Monthly 100 Hours 6 Months
Spindle grease 370 PP / S as needed
Air Regulator oiler 370 PP / S check / add
Head Feed Cylinder Oil 370 PP / S add as needed
Coolant 370 PP / S check / add change
Chip Drawer 370 PP / S empty
Gib Adjustment (Head) 370 PP / S check as needed