Dake Euromatic 370 S, Инструкция по эксплуатации

Страница: 21 / 64

370 S 370 S L 370 PP 370 PP L
21
SETTING THE BLADE PROTECTOR PARAMETERS
370PP
CONTROL FUNCTIONS
A. This scale shows the actual amps being drawn by the motor, during operation via LEDS.
B.
This scale allows you to program shut off amps. Wet approx. 2 amps higher than the freewheeling amps. (amp draw
while machine is running, but not cutting)
C.
Write in area for recording parameters such as min. amp draw, blade shut off setting, max. Amp draws during cutting
cycle and average constant amp draw.
D.
Test switch, for testing the scales LED’s. (Factory preset no adjustment needed)
E.
LED is illuminated when ever preset shut off amps have been met and the blade shuts off.
F. Press this button when preset amps have been met and the LED is illuminated. Press this button to reinstate power to
the controls, allowing restart of the cycle.
G. Knob to set your preset shut off amps. This controls the LED’s on the bottom scale.
H.
Calibration adjusting screw. (Factory preset and no adjustment needed)
Features
Operator sets shut off amps, 2 amps above free wheeling amps. If blade is dull, wrong for the material being cut or the head
feed is excessive. The amps will peak to your preset amps and shut the saw off. This prevents damage to the blade, saw and
material, this will prevent over feeding that can give you a poor finish and shorten blade life.
You can monitor blade life by recording the amps being drawn, while cutting and using a new blade. When the blade dulls the
amps increase.
The shut off amp settings are adjustable and allows adjustments for different materials and different blades.
Warning!!!!!
Setting amps too high may cause motor to over heat, machine or blade damage.
BLADE PROTECTION CALIBRATION