Dake Euromatic 370 S, Инструкция по эксплуатации

Страница: 11 / 64

370 S 370 S L 370 PP 370 PP L
11
Close the safety guard then turn on the power to the machine. Close the head feed control knob to the “0” setting. (
370PP Place the Automatic / Semi-Automatic switch in the Semi-Auto mode The hand symbol). Make sure head is in the up
position (making contact with the upper parameter limit, this limit is the bottom one). Place the speed selector switch on either
“1” or “2”. Press the start button (370PP the green button 370S the yellow button) and take notice of the blade rotation, to stop
the blade rotation press the emergency stop button.
If properly wired the blade will rotate: (in accordance with the arrow on the blade guard)
Ferrous Head in a Counter Clockwise direction
Non-Ferrous Head in a Clockwise direction
If rotation is incorrect consult your electrician.
Add coolant to the machine. Using the coolant supplied with your saw (or any water Soluble coolant concentrate) mix
per manufactures instructions (normally 10 to 1) in a container or bucket. Next pour the mixed coolant into the machine coolant
pan, which can be pulled outward to fill. With the machine in Semi-Auto mode, (be sure the head feed control knob is set at
“0”) press the start button. (With the 370PP you will have to push the yellow button after pushing the green button for the
coolant to come on). This will start the motor and the coolant will flow. The valve right above the blade guard on the right will
allow you to regulate the flow of coolant. This can be varied to the type of cutting you doing.
Do not use cutting oil in this machine!!!
I:
Familiarize your self with all the warning labels
.
Check with your safety committee on the proper lock
out procedures. These procedures should be followed at all times maintenance is performed, including blade changes.
K:
Take time now to familiarize your self with the control panel’s functions, using the graphic on
the page 9 and 10.
BLADE SELECTION SPEEDS AND FEEDS
Proper Blade Selection 370PP 370S
The most important decision you will make on your machine is selecting the Right Blade for the Material. The larger
the part, the more coarse of blade. The smaller or thinner the part the less coarse of bladeAn improper blade will sacrifice the
quality of cut, safety and blade life. When in doubt use the slide pitch calculator provided with the machine. If you are not sure,
do not hesitate to call DAKE for a recommendation.
Warning!!!!!!
Never use a blade that is cracked, dull, or missing teeth
.
Different blade types
There are many different grinds that can be put on a blade. A special grind may work for you. Call Dake for
information on these blades. Special coated blades are also available, such as cobalt. These blades can increase blade life
considerably on certain applications. The blade thickness can affect the way the blade will cut. A thinner blade may work better
for you if you are cutting thin wall tubing. The thinner blade has to remove less kerf, meaning the blade cuts less material, and
cuts faster without out distorting the tube. A thicker blade such as a 3mm is more rigid and will flex less cutting heavy material.
Each high speed steel blade can be reground up to about 20 times. If done properly.
CAUTION!!!!
Always have blades reground by a qualified professional. Always use blade with proper pin hole
spacing.
Speeds and feeds
The best way for determining this, is by sound, and chip appearance. With the proper blade the machine will cut
smooth and throw a curly chip. The chip should be shinny, curly, and cool to the touch. If the chip is bent into a curl, discolored
and/or hot, the feed rate may be too fast. If the chip is powdery or splintered the feed rate may be too fast, too slow or the
incorrect blade is being used. Rule of thumb, if it sounds good and the chips look good you have it set right.