- 30 -
Chapter 4 Recording of operation data
* Eight items per an air conditioner for analog data and digital data are
displayed respectively. By placing the cursor in a data item to be displayed
and pressing the [F12] key, the data item is marked at the left end by * and
its graph is displayed in the left side of the window at the same time.
* In case of ending a graph displayed by a data item, place the cursor in the
data item on the list at the right in the window and press the [F12] key.
(Notes)
1. In the PCB connection, the data item with [***Retry] does not show [Retrying],
but shows to have retried before.
2. On the data item of an indoor unit connected to the PCB, [Internal and
external transmission error] shows the state that due to an indoor unit
’
s error,
signal transmission between an indoor unit and an outdoor unit cannot be
performed. [Indoor unit error] shows the error state that it is impossible for an
indoor unit to switch thermostat ON. [System error] shows that the overall
system between an indoor unit and an outdoor unit is error. [Error between
remote controllers] shows the error state between an indoor unit and a remote
controller.
3. Because of not covering all of model classification in the TYPE 3 software,
small horse-power models may display the items of not existing sensors and
actuators.
Neglect this and refer to the Service Manual in detail.
(4) Press the [Cancel(ESC)] to return to the window of the [Network Map Display].
