Operating instructions
10
Daikin RoCon HP
Daikin Control
008.1420844 – 05/2014
3
x
Operation
Tab. 3-5 Description of the operating data displayed as an overview
Info
Overview
Water Pressure
Off
Fig. 3-5
Display operating data overview
Displaying the water pressure
On the Control RoCon HP, when it is switched on, you can
display the system pressure (water pressure) in the internal
circuit (direct heating circuit). The water pressure is available as
the first info parameter (see fig. 3-6).
The permissible range of water pressure during operation de-
pends on the Daikin Altherma EHS(X/H) and the heating system.
The set values and threshold values must only be changed by the
heating technician. If the water pressure falls below the minimum
value (set parameter value), it must be increased by topping up
the system (see installation instructions of the Daikin Altherma
EHS(X/H)).
The pressure limits for the safety switch-off and the set
pressure can be adjusted in the parameter settings in
level
"System Configuration"
.
Info
Overview
Water Pressure
T-HS
Water Pressure
Fig. 3-6
Info values display (e.g. system pressure)
Page
3
TVBH2 = TVBH
TR2
Current heating return flow temperature, sec-
ondary sensor (t
R2
)
Tdhw2 Current temperature in domestic hot water
storage tank, secondary sensor (t
DHW2
)
Tliq2
Current coolant temperature (t
L2
)
TA2
Actual outdoor temperature (measured by tem-
perature sensor of the external heat pump)
quiet
Shows the status of the whisper mode
Short
designation
Explanation of the displayed value
