30
English
Advanced Settings
Function
1
2
3
4
Active Plasma Ion Output
Setting
(ON/OFF)
Setting at the time of purchase: ON
If the odour of ozone bothers you, set active
plasma ion output to “OFF”.
•
If set to “OFF”, active plasma ion discharge
stops, however, dust and odour removal
continues.
• If the odour of ozone continues to bother you
even after output has been set to “OFF”, set
streamer output to “Low”.
Setting can be performed either
during operation or while operation is
stopped.
Press
for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down
.
When a short beep
sounds, release
and
.
The AUTO operation lamp
blinks, then lights up.
[Blinking
→
Lit up]
According to the current setting,
the Humidity setting lamp will
turn from blinking to lit up.
“ON”
“OFF”
Press
to change the setting*.
Each press cycles between “ON” and
“OFF”.
“ON”
“OFF”
Press
.
A short beep sounds, the AUTO
operation lamp blinks, and the set
Humidity setting lamp will blink.
[Blinking]
“ON”
“OFF”
While the lamp is blinking,
unplug the power supply
plug, wait at least
5 seconds, and then insert
the power supply plug
again.
Setting is now complete.
Power supply plug
Power socket
• If this procedure is not performed,
the unit will not return to regular
operation mode.
• The settings will be remembered
even if the power supply plug is
removed.
PM2.5 sensor Sensitivity
Setting
(Low/Normal/High)
Setting at time of purchase: Normal
The sensitivity setting of the PM2.5 sensor can
be set to “Low/Normal/High”.
•
“Low” makes the sensor less responsive, and
“High” makes the sensor more responsive.
Setting can be performed either
during operation or while operation is
stopped.
Press
for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down
.
When a short beep
sounds, release
and
.
According to the current setting,
the FAN lamp will turn from
blinking to lit up.
“Low”
“Normal”
“High”
Press
to change the setting*.
Each press cycles between “Low”,
“Normal” and “High”.
“Low”
“Normal”
“High”
Press
.
A short beep sounds, and the set FAN
lamp will blink.
“Low”
“Normal”
“High”
* If the lamps do not change even after the settings were changed, unplug the unit, wait at least 5 seconds, then re-insert the power supply plug and
repeat the above procedure from the beginning.
01_EN_3P693798-1B.indd 30
2023/06/26 13:34:07
Содержание MCK70ZVM-W
Страница 114: ...57 MEMO 02_TR_3P693798 1B indd 57 2023 06 26 13 39 11...
Страница 115: ...58 02_TR_3P693798 1B indd 58 2023 06 26 13 39 11...
