Daikin EPRA08EAV3, Руководство по установке для специалистов

Страница: 204 / 292

10 | Configuration
Installer reference guide
204
EPRA08~W1 + ETVH/9W
Daikin Altherma 3 H MT F
4P634886-1 – 2021.03
Recommended on :
▪ In case the space heating/cooling request is OFF and the tank temperature
setpoint is reached, the unit can choose to buffer energy from the photovoltaic
panels in the room (only in case of room thermostat control) or in the DHW tank
instead of putting the photovoltaic panel energy on the grid.
In case of room buffering, the room will heat up or cool down to the comfort
setpoint. In case of tank buffering, the tank will heat up to the maximum tank
temperature.
▪ The goal is to buffer the energy from the photovoltaic panels. Therefore, the
capacity of the unit is limited to what the photovoltaic panels are providing:
If Smart Grid pulse meter is… Then the limit is…
Available Decided by the unit based on the input
of the Smart Grid pulse meter.
Not available Decided by [9.8.8] Limit setting
kW
▪ The protective functions (water pipe freeze prevention, drain prevention, room
frost protection, tank disinfection) and defrost are NOT overruled (capacity will
not be limited for these functions)
Also see "Protective functions" [
4
213].
Forced on
:
Similar to Recommended on , but there is no capacity limitation. The goal is NOT to
use the grid as much as possible.
Emergency mode. In case emergency mode is active, buffering with electrical
heater is NOT possible in Forced on and Recommended on operation modes.
Power consumption control
Power consumption control
See "6 Application guidelines" [
4
32] for detailed information about this
functionality.
# Code Description
[9.9.1] [4-08] Power consumption control :
▪ 0 No : Disabled.
▪ 1
Continuous
: Enabled: You can set one
power limitation value (in A or kW) to which
the system power consumption will be
limited for all the time.
▪ 2 Inputs : Enabled: You can set up to four
different power limitation values (in A or kW)
to which the system power consumption will
be limited when the corresponding digital
input asks.
[9.9.2] [4-09] Type :
▪ 0 Amp : The limitation values are set in A.
▪ 1 kW : The limitation values are set in kW.
Limit when [9.9.1]= Continuous and [9.9.2]= Amp :