To remove intermediate seats, perform the following operations:
1) Install protective covers.
2) Pull backrest bottom upholstery to remove it.
CAUTION
Make sure to disconnect the seat heating system and the
headset plug harnesses before the removal of the seat to
prevent harness damage.
3) Disconnect both the heating system and the headset plug
harnesses. Clip the loose connectors to the holders located on
the seat structure.
4) Clear the carpet from under the seat to facilitate moving in rails.
5) Open the floor hatch and clip the loose connectors to the holders
located under floor panel. Close the floor hatch.
6) Pull up locking handle located under the pan, on the seat rear
side, to unlock it.
7) Move the seat in the rails to line up pads with rail apertures.
8) Remove the seat.
9) Install backrest bottom upholstery.
CAUTION
In order to prevent deflectors damage, it is necessary to
remove them.
10) Remove deflector maintained with self-gripping strap.
11) If necessary, remove the cabin central carpet.
NOTE
If one of two cargo nets must be installed, it is necessary to
use the carpet with appropriate cuttings.
E. Removal of a cabinet
NOTE
This operation must be carried out by a service center.
F. Installation of intermediate seats – see
Section 8
Handling, Servicing and Maintenance
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 01
Page 8.9.3
PIM - DO NOT USE FOR FLIGHT OPERATIONS