Daedong Kioti LK30, Руководство по ремонту

Страница: 85 / 326

2-33 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
643W2D1A
265W286A
5.1 FAN BELT
1. Measure the deflection, depressing the belt half-
way between the fan drive pulley and the alternator
pulley at 78 N (8 kgf, 18 lbs) of force.
2. If the deflection is not between the factory specifica-
tions, loosen the bolts and nuts, and relocate the
alternator to adjust.
3. If the belt is damaged or worn (See figure), replace
the belt.
5.2 RADIATOR WATER TIGHTNESS
1. Fill radiator with water to the specified amount and
warm up the engine.
2. Set a radiator tester and raise the water pressure to
the specified pressure.
3. Check the radiator for water leaks.
4. Pinhole water leaks may be repaired with radiator
cement. Larger leaks require radiator replacement.
265W287A
5. MEASUREMENT AND ADJUSTMENT
265W288A
5.3 RADIATOR CAP TIGHTNESS
1. Attach a radiator tester on the radiator cap.
2. Apply 88 kPa (0.9 kgf/cm², 13 psi) of pressure and
measure the pressure for 10 seconds.
3. If the pressure falls below 59 kPa (0.6 kgf/cm², 9 psi),
replace the radiator cap.
7 ~ 9 mm
0.28 ~ 0.35 in.
at 78 N (8 kgf, 18 lbs)
of force
Belt tension (direction)
Item Factory spec.
No leaks at 137 kPa
(1.4 kgf/cm², 20 psi)
Radiator water tightness
Item Factory spec.
More than 10 seconds
for pressure fall
from 88 ~ 59 kPa
(0.9 ~ 0.6 kgf/cm², 13 ~ 9 psi)
Radiator cap tightness
Item Factory spec.
ENGINE - MEASUREMENT AND ADJUSTMENT
Lk30_02_engine(01-38).p65
2007-07-26, ¿ÀÈÄ 12:04 Page 33
Adobe PageMaker 6.5K/Win