Daedong Kioti LK30, Руководство по ремонту

Страница: 66 / 326

2-14 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
3.1.9 TIMING GEARS
The crankshaft drives the oil pump and the idle gear
engages the fuel camshaft and camshaft. The timings
for opening and closing the valves are extremely im-
portant to achieve effective air intake and sufficient gas
exhaust. The appropriate timing can be obtained by
aligning the mark on the crankshaft gear with (6) the
one on the idle gear (5), the idle gear with camshaft
gear (3), idle gear (5) and with injection pump gear (1).
(1) Injection pump gear (5) Idle gear
(2) Fuel camshaft (6) Crankshaft gear
(3) Camshaft gear (7) Crankshaft
(4) Camshaft
3.1.10 FLYWHEEL
The flywheel is installed on the rear end of the crank-
shaft and stabilizes the irregular driving force with its
large moment of inertia. The flywheel has a ring gear
(1), which meshes with the drive pinion of the starter.
The flywheel has marks “TC” and “FI” on its outer rim.
The mark TC shows the piston’s top dead center and
the mark FI shows the fuel injection timing, when they
are aligned with the mark of window on the clutch
housing.
• Injection Sequence
Three Cylinders: 1
→
2
→
3
(1) Ring gear (3) Crankshaft
(2) Flywheel
196W218B
196W219B
3.1.8 INLET AND EXHAUST VALVES
The inlet and exhaust valves and their guides are dif-
ferent from each other. Other parts, such as valve
springs, spring retainers, valve spring collets, valve
stem seals, valves and all contact or sliding parts are
covered and tempered to resist, wear.
(1) Valve spring retainer (5) Valve guide
(2) Valve spring collets (6) Intel valve
(3) Valve spring (7) Exhaust valve
(4) Valve stem seal
196W217A
ENGINE - OPERATING PRINCIPLE
Lk30_02_engine(01-38).p65
2007-07-26, ¿ÀÈÄ 12:04 Page 14
Adobe PageMaker 6.5K/Win