Daedong Kioti LK30, Руководство по ремонту

Страница: 231 / 326

7-15 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
5.1.11 PRE-LOAD OF TAPER ROLLER BEAR-
ING ON SPIRAL BEVEL PINION SHAFT
704W732A
• If measuring the pre-load of the bearing as-
sembled to the front axle as shown in the figure
(A), measure it before inserting the oil seal and
installing the 23 bevel gear.
• If measuring the pre-load while securing the spi-
ral bevel shaft and taper roller bearing assembly
with a vice as shown in the figure (B), cover the
bearing cover with cloth.
IMPORTANT
1. After wrapping the pinion shaft with a string, mea-
sure the load by pulling the string with a pull scale.
• When measuring the load by engaging torque
wrench to spline of spiral bevel pinion shaft as
shown in the figure (C):
Item
Load of pull scale
Factory spec.
8.3 ~ 10 kgf
18.3 ~ 22 lbs
Item
Torque value
Tightening torque
0.980 ~ 1.176 Nm
0.1 ~ 0.12 kgf-m
0.72 ~ 0.87 lbs-ft
• When measuring the load by a pull scale as shown
in the figure (A, B):
Load of
pull scale (F) (kgf) =
F =
F = 8.3 ~ 10 kgf (18.3 ~ 22 lbs)
Torque value (T) (kgf-m)
Radius of spline shaft (R)
0.1 ~ 0.12 kgf-m
R (0.0123 m)
Cloth
A B
C
FRONT AXLE - SERVICING
Lk30_07_front axle.p65
2007-07-26, ¿ÀÈÄ 12:05 Page 15
Adobe PageMaker 6.5K/Win